How to Care for Acrylic Stands: Spy x Family Anya Edition

By TOHO animation Store | US | Published: 2026-10-31

Category: Tips & Care

Keep your Spy x Family Anya acrylic stand clear and scratch-free with a simple cleaning, handling, and storage routine that protects the print and the edges.

Quick answer

Dust your Anya acrylic stand with a soft, dry microfiber cloth, clean smudges with lukewarm water and a drop of mild dish soap, and store it upright with its protective film or a soft sleeve. Skip alcohol, ammonia, and paper towels, which dull the print and leave micro-scratches.

Why acrylic needs a gentler routine than glass or plastic

Acrylic is lightweight and clear, but its surface is softer than glass and scratches easily. The printed illustration on an acrylic stand sits on or just under that surface, so abrasive cloths, gritty dust, and solvent cleaners can wear away the image rather than just the shine.

The Anya as Sylvia stand is roughly 3.9 by 7 inches, which means a large printed face and thin edges are both exposed. Handle it by the base or outer edges, not by the printed area, to avoid fingerprints and flexing the panel.

When to clean versus when to leave it alone

You do not need a weekly deep clean. Dust is the main enemy, so a quick dry wipe every week or two is usually enough. Save the wet clean for visible fingerprints, sticky residue, or a haze that dry cloths will not lift.

If your stand sits in direct sun or near a heater, move it first. Acrylic can warp with sustained heat, and no cleaning routine will fix a bent panel.

Step-by-step acrylic stand care

Clear the display area: Lift the Anya stand by its base and move it to a clean, flat surface away from other figures. Common mistake: cleaning in place and knocking the stand over, which can chip the base corner. Check that the base is not cracked before you start; a loose base needs gentle handling, not a full wash.
Dust dry first: Wipe the whole stand with a clean, dry microfiber cloth using light straight strokes. Do not press hard or circle over the printed face. Common mistake: using a paper towel or tissue, whose fibers and grit drag across the acrylic. If the cloth picks up grit, shake it out outdoors before the next pass.
Mix a mild wash: Fill a bowl with lukewarm water and one drop of mild dish soap. Never use hot water, alcohol, ammonia-based glass cleaner, or acetone. Common mistake: spraying cleaner directly onto the stand, which can seep into the base joint. Test any cleaner on the back edge first and stop if the surface looks cloudy.
Wipe, then rinse: Dip the microfiber cloth, wring it nearly dry, and wipe the printed face and edges gently. Follow with a second cloth dampened with plain water to remove soap film. Common mistake: leaving soap residue, which attracts dust and dulls the image. Keep water away from the slot where the panel meets the base.
Dry fully before display: Pat the stand dry with a clean microfiber cloth and let it air-dry upright for a few minutes. Do not use a hair dryer or direct sun. Common mistake: reassembling a damp stand, which traps moisture and spots the acrylic. Check the base slot is dry before you slide the panel back in.
Store upright and covered: For storage, keep the stand upright in its original protective film or a soft cloth sleeve, in a cool, dry box away from sunlight. Do not stack heavy items on top. Common mistake: storing it flat under books, which bows the panel and presses dust into the print. Label the sleeve so you do not slide the stand against a hard edge when retrieving it.

Product facts

Spy x Family Anya Forger as Sylvia Acrylic Stand: The stand measures approximately 3.9 by 7 inches and is made of acrylic. The tall printed panel gives you a large area to dust, so use a cloth large enough to wipe in one direction rather than scrubbing small spots.
Spy x Family Anya Forger as Sylvia Acrylic Stand